Brentwood, NY 631-231-4500 Call Us Email Us


Model CSWI Industrial Swing Gate Operator

The CSWI Operator controls industrial vehicular swinging gates up to 1800 pounds, with a maximum width of 30 feet. Units can cycle up to 45 times per hour, with a gate speed of 18 seconds from open to close.


Industrial Swing Gate Operator

Specifications & Features

  • Available horse power: 1/2 HP – 2 HP
  • Power requirements: 115/230 Volts, 1 phase; or 230/460 Volts, 3 phase
  • Class II low voltage control circuit
  • Gate Capacity: 1800 lbs, 30 ft wide, up to 45 cycles per hour
  • Travel speed: 18 seconds to full open or full close
  • UL 325 Listed for use in Class I through IV application
  • Shipping Weight: approx. 350 lbs (includes pallet)
  • Shipping Dimensions: 19″ x 20″ x 41″
  • Solid state control board with diagnostic LEDs to indicate all input and output functions
  • External control input terminal connections for:

  • Radio Receiver
  • Push Button Control Station
  • Key Switches
  • Loop Detectors
  • Card Key Readers
  • Telephone Entry Systems, Etc.

  • Timer to close with 0-60 sec. Adjustment standard. Longer timer available upon request.
  • Maximum run timer for equipment protection (self-adjusting)
  • Master/Slave option with dedicated terminal connection provided
  • Easy Left/Right changeover
  • Time delay on reverse to ensure smooth gate motion and less stress on equipment
  • Spike suppressing circuitry for surge and lightning protection
  • Emergency control enabling circuitry for safety with security
  • Electrical dynamic brake for precise gate positioning
  • Integral current sensing anti-entrapment circuitry with independent opening and closing sensitivity adjustment
  • External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors
  • 1/2 HP., 115 Volt AC, 6 Amp., 1 Phase, instant reversing, switchless, PSC motor, with thermal overload protection and high speed ball bearings for smooth, quiet operation.
  • Internal On/Off power switch
  • Two grounded 115 Volt AC, 15 Amp. Convenience receptacles.
  • NEMA 1 three-button control station included.
  • Heavy duty #7 Ga. Steel frame providing a strong and durable unit
  • Hard shell, baked-on, weather resistant powder coating
  • Timing belt primary reduction for smooth, quiet and positive operation
  • Heavy duty 60:1, oil bath type gear reducer for long service and dependable operation
  • Heavy duty #50 sprocket and roller chain arrangement for final drive reduction
  • Heavy duty pillow block type ball bearings supporting output drive shaft and enabling extended endurance under heavy loads with low maintenance
  • Drive arm easily disconnected for manual operation in case of power failure
  • Easily adjustable limit switch cams for precision gate positioning
  • Pad mounted for a strong, solid installation

Downloadable PDFs