1/2HP PSC Motor
Power requirements: 115 Volts, 1 phase
Class II low voltage control circuit
Gate Capacity: 800 lbs, 16 ft wide, up to 24 cycles per hour
Travel Speed: 12 seconds from open to close
UL 325 Listed for use in Class I through IV application
Nitro board with LCD display
External control input terminal connections for:- Radio Receiver
- Push Button Control Station
- Key Switches
- Loop Detectors
- Card Key Readers
- Telephone Entry Systems, Etc.
Timer to close with 0-60 sec. Adjustment standard (Longer timer available upon request)
Maximum run timer for equipment protection (self-adjusting)
Dual gate option with a dedicated terminal connection provided
Easy Left/Right changeover
Time delay on the reverse to ensure smooth gate motion and less stress on equipment
Spike suppressing circuitry for the surge and lightning protection
Electrical dynamic brake for precise gate positioning
Integral current sensing anti-entrapment circuitry with independent opening and closing sensitivity adjustment
External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors
Internal On/Off power switch
Heavy duty #13 Ga. Galvanized steel frame provides a strong and durable unit
Hard shell, baked-on, weather resistant powder coating
Industrial V-belt primary reduction for smooth quiet operation
Heavy duty 30:1 oil bath type gear reducer for long service and dependable operation
#41 Sprocket and roller chain arrangement for final drive reduction
Oil impregnated brass bearings supporting output drive shaft for dependable service with low maintenance
Drive arm easily disconnected for manual operation in case of a power failure
Easy adjustable limit switch cams for precision gate positioning
Soft start and soft stop
Post or pad mountable for easy installation
Shipping Weight: approximately 103 lbs
Shipping Dimensions: 40″x6″x6″
